Driver sd needs updating ubuntu

dmesg | grep eth [ 2.090548] Driver 'sd' needs updating - please use bus_type methods [ 2.090565] Driver 'sr' needs updating - please use bus_type methods [ 3.685275] eth0: Davicom DM9102 at pci00:0a.0, :ad:01:0e:68, irq 11. Unlike the attached dmesg output, mine contains lots and lots of "eth0: Tx Timeout - resetting" messages. I blacklisted "tulip" module and enabled dmfe module I also used "options dmfe mode=4" to enable full duplex 100mbps I also used "pci=noacpi" boot flag.[ 11.603829] udev: renamed network interface eth0 to eth1 [ 23.467472] ADDRCONF(UP): eth1: link is not ready ifconfig -a eth1 Link encap: Ethernet HWaddr :ad:01:0e:68 UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:0 errors:0 dropped:0 overruns:0 frame:0 TX packets:4 errors:0 dropped:0 overruns:0 carrier:0 Yes, I concur. Hope this is fixed soon so that I can dump my win installation.seconded. Yet, I get "eth0: Tx Timeout - resetting" messages please fix this - we have several machines in our office using this network card. i usually don't check my mail on weekends ;-) Coming to the issue, yes, I still have it on my system, even after upgrading it to Lucid.To hotplug, in System/Preferences/Removal Drives and Media, Storage tab must be set to "mount removal drives when hot-plugged".

They are run by the udev service and the service is blocked until the script returns, so you may wreck your udev service if your script takes too long.Listmates, Another curiosity are the following dmesg errors related to a 'sd' driver that needs updating. You can blacklist unwanted modules or load specific modules by updating initramfs.Press the "Super" key -- also called the Windows key -- then type "Additional Drivers" (without quotes) and press "Enter." If any proprietary drivers are available for your system, Ubuntu finds them and recommends the best ones for your hardware. If proprietary drivers are available for several components, such as wireless cards, video cards or sound cards, you can install drivers for each device.This article describes how to automatically run a script when a USB drive is inserted.

'Hot-plugging' means inserting/removing a drive while a computer is turned on.I've tried loading tulip and dmfe with no luck.Also tried appending dmfe on /etc/modules and blacklisting tulip, also no luck.With Ubuntu 14.04 and other Linux distributions, you have the choice to use open- or closed-source drivers for hardware that benefits from proprietary software.Ubuntu automatically updates installed drivers and notifies you of proprietary upgrades, but you still need to know a little about your hardware to choose the best drivers.[17197212.184000] usb 5-6: new high speed USB device using ehci_hcd and address 2 [17197212.420000] Initializing USB Mass Storage driver...